![]() ![]() ![]() On 1), I know there are often many ways to accomplish the same thing. I do have a planer, so perhaps if I used it (or even my table saw) to make the wood more square this would be less of a problem. I think one issue is that I have trouble holding the pieces straight when cutting because 2x4's are curved around the edges. Hopefully when I get my miter slide (or whatever it's called) that will help with 2). How to accurately cut said measurements.But there are two things I need to improve on: And to be honest, the fact I even made it all fit together is encouraging to me. I wish I still had enough math skills to draw this on paper and determine where my cuts should be, but sadly I don't so that's why I just tried to position pieces and trace around them. I'm not necessarily looking for perfection, but I would like to at least get the bubble in the center section on the level. Sadly, my new bandsaw saw was missing the miter slide (I've emailed the manufacturer and hope to receive it soon), so I had to make the cuts freehand.Īs you can see, the bubble on the level is all the way to the right. Using the right angle triangle block, I positioned the cross brace by hand such that it was going into both the other 2x4's equally and then traced around it in pencil. I had the 9" (on the long side) cross brace from my previous attempt, and I had a right angle triangle block that was conveniently the perfect size to help me align it such that it would go into the other 2x4's about half way. After applying a corner clamp, it became clear that it wasn't a perfect 45 degrees, but it was pretty close. Use my miter saw to angle the ends to 45 degrees. I liked using the bandsaw for this a lot better, but I don't know how to properly measure my cuts. The first time I used a table saw to cut the slots, and this time I used a band saw. Pictured below is my second attempt at this. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |